GPAC Portable Power Solutions for Pacific Crest

Utilizing a 12 volt 35 amp hour Sealed Lead Acid Battery (SLA) enclosed within a 1000 denier, highly visible safety orange Ballistic Nylon case; the 1235 features 2 fused 20 amp outputs with Anderson Power Pole connectors and a covered SAE 2-pin connector with a built-in cable pouch that houses the output cable connectors, cables and accessories. The case is equipped with non-conductive heavy duty zippers and a soft grip carry strap.

Weighing in at just under 25 pounds the 1235 carries easy and delivers power to spare.

The fused outputs and polarity protected Anderson Power Pole connectors insures that the equipment under power is well protected from short circuits and reverse polarity problems that can happen with power cables equipped with alligator clips.

The covered SAE 2-pin mates with all Pacific Crest flat 2-pin SAE connectors. Running in the high power mode, the 1235 will run approximately 8 hours with a full charge. Typically a PDL, HPB or RFM96W draws approximately 4 amps in High Power Mode. So the 1235 can power the GPS at the same time it powers the Pacific Crest and still give you a days service on a single charge. Cables are available to supply power to most brands of GPS equipment including Trimble, Leica, Topcon, Ashtech and Sokkia.

GPAC 1235 Battery Pack for Pacific Crest Base Radio, HBP; RFM96W

This is a complete kit, consisting of:

• 1000d Ballistic Nylon Case with a zippered cable compartment
• 12 Volt 35 Amp Hour Sealed Lead Acid Battery
• 2 - 12 volt outputs fused at 20 amps
• 1 - SAE 2-pin connector
• 13.8 Volt 4 Amp Dual rate Automatic Charger / Maintainer and Charger Cord
• 2 -20 amp mini fuses
• 1 set of Anderson Power Poles to retrofit an existing power cable
• 2 cable retainers to prevent accidental cable disconnection during use as a rover battery pack or any time a semi-permanent connection is desired (installs easily and can be removed without tools).

Part Number: 1235P1